濟南抹面砂漿是由混凝土、石英砂、高分子細砂等多種防腐劑與機械設備混合而成的對稱型膠粘劑,適用于粘接保溫板膠粘劑,又稱高分子膠凝砂漿。在當代建筑工程建設項目導入綁定砂漿,能擁有出色的靈活性和凝聚力,和它的水溶性好,耐磨性及其方便的可操作性,提高了板和保溫隔熱板中間的膠的抗壓強度,提高抗拉強度,處理接字層下降之間的墻面空鼓,如產品質量問題。
Jinan plastering mortar is a kind of symmetrical adhesive which is composed of concrete, quartz sand, polymer fine sand and other preservatives mixed with mechanical equipment. It is suitable for bonding insulation board adhesive, also known as polymer cemented mortar. The introduction of binding mortar in contemporary construction projects can have excellent flexibility and cohesion, and its good water solubility, wear resistance and convenient operability, improve the compressive strength of the glue between the board and the heat insulation board, improve the tensile strength, and deal with the hollowing of the wall between the drop of the joint layer, such as product quality problems.
為了保證工程施工膠黏劑的實際效果,防止保溫板出現不充分掉落的現象,同時也減少木材奢侈浪費,在前期準備膠黏砂漿時要特別注意以下幾種制備方法:
In order to ensure the actual effect of the construction adhesive, prevent the insufficient falling of the insulation board, and reduce the luxury and waste of wood, the following preparation methods should be paid special attention to when preparing the adhesive mortar in the early stage:
抹面砂漿的本質是擠塑聚苯板安裝,在整個生產過程中相關施工隊伍發展的粘結砂漿應嚴格執行實施相對原料選擇和準備,比例可能按照水泥灰漿和水的比例為4比1。
The essence of plastering mortar is the installation of extruded polystyrene board. During the whole production process, the bonding mortar developed by the relevant construction team should strictly implement the selection and preparation of relative raw materials. The proportion may be 4:1 according to the proportion of cement mortar and water.
根據水泥砂漿的實際要求,對原材料進行嚴格的計量,并注意整個攪拌過程的對稱性。次混合膠后,還需要每隔12分鐘進行一次再混合的工作。另外,成功后的膠粘劑應注意其貯存,避免水分蒸發過快,需要注意攪拌均勻,攪拌材料應在2小時內用完。
According to the actual requirements of cement mortar, the raw materials shall be measured strictly, and the symmetry of the whole mixing process shall be noted. After the first mixing, it is necessary to mix again every 12 minutes. In addition, the successful adhesive should pay attention to its storage to avoid too fast evaporation of water, and attention should be paid to even mixing, and the mixing materials should be used up within 2 hours.
以上是濟南抹面砂漿廠家為大家介紹的相關內容,想要了解更多內容,歡迎訪問網站:http://www.chnzylw.comThe above is the relevant content introduced by Jinan plastering mortar manufacturer. To learn more, please visit the website: http://www.chnzylw.com